You are buying a set of two (2) water slide decals for a vintage Flottorp aircraft propeller. Part No. FDS-0023

These water slide decals are made with actual gold crushed leaf, and color enamel. They are made just like the originals. They measure 3 1/2" across.

Mounting Instructions: Prepare a pan of warm water. When you put the decal in the water, it will want to curl up, but with wet hands, keep it under the water, and it will flatten out. Wait about a minuet or two, then while still in the pan, try sliding the decal to the edge of the paper. It will move easy when it is ready to slide off. Pull it out of the water, and with wet hands, place the decal paper in the area you want on the propeller. With wet hands, slide the decal to the propeller, and with the other hand, pull the paper out from under the decal slowly. Then, with wet hands, carefully squeegee out any excess water and air bubbles. You will have time to re-position the decal a little before it sets up. Let it dry for 24 hours before clear coating over it.

This set of two (2) are "ONE" set of "7" sets, that were custom made by Nostalgic Reflections of Veradale, Washington who makes custom "One Off" parts for their customers who own, and restore antique vehicles; cars, trucks, airplanes, motorcycles, bicycles, boats, tractors & snowmobiles.

NOTE: BEFORE MOUNTING THIS ON YOUR VINTAGE AIRPLANE, PLEASE REVIEW FAA RULE 14 CFR 45.13

Insured shipping and handling in the USA is $8.00 and International is $29.75

Be sure to check out our other listings for rare, hard to find, or unique parts.