CONTINENTAL Valve Cover Gasket - FITS C-85, O-200 & more- # RG-530162 SiliconeClick here to purchase or contact the seller of this item on eBay |
|
|
| Current Price: 19.99 USD |
VALVE COVER GASKETS - SILICONE
for
CONTINENTAL Engines
A-65; A-75; C-75; C-85; C-90; C-125, C145,
O-200; IOL-200; O-300; GO-300; IOL-300
Specific engines listed below.
- Our silicone rubber gaskets are made from aerospace
mechanical grade AMS silicone and designed to
withstand temperatures up to 400 degrees Fahrenheit.
- Therefore, they will not break down and deform or crack up
like cork or neoprene.
- Our gaskets seal uneven and warped surfaces, plus
eliminates corrosion.
- Gaskets are 100% reusable.
FAA-PMA FOR CONTINENTAL ENGINE MODELS:
A-65; A-75;
C-75; C-85; C-90;
C-125-2;
C-145-2, -2H;
O-200; IOL-200;
O-300-A,-B,-C,-D;
GO-300-A,-B,-C,-D,-E;
IOL-300
PART #: RG-530162
OEM # 530162
SUPERSEDED OEM NUMBERS: 655706, 653728, 653192, 649985, 530162, 3500
Gaskets have six bolt holes and are 1/8" thick silicone.
Price is per gasket.
Reusable.
INSTALLATION AND MAINTENANCE PROCEDURES:
THE GASKET SURFACES MUST BE CLEAN AND DRY.
1. Remove the valve cover and gasket in accordance with the
Continental procedure or in accordance with an acceptable
procedure used by the shop performing the installation.
2. Clean the valve cover and the cylinder surfaces of all residual
material.
3. Install gaskets, DRY.
4. Replace the valve cover and torque the cover bolts to 25 in-lbs.
"CAUTION" - DO NOT OVER TIGHTEN.
Over tightening makes the gasket bulge of squeeze out.
5. Check the cover bolt torque after an engine run up to take off power or
first flight and re-torque the bolts to 20 in-lbs.
6. Check the cover bolt torque annually, and re-torque to 20 in-lbs, if necessary.
The gaskets are re-usable and the service life of the gasket is
determined by its physical condition on removal.
If the gasket is still pliable and without cracks, tears,
or deterioration, it may be re-used, otherwise discard.
TO REUSE GASKETS:
Wash briefly in hot soapy water.
Rinse well and dry all surfaces.
Re-install using the above installation instructions.
Save instructions for future reference.
Instructions do come with the gaskets.
|
Click here to purchase or contact the seller of this item on eBay